ADEMCO Security System VISTA-15CN Guide d'installation Page 43

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 132
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 42
8–1
SECTION 8
4285 & 4286 VIP Module
••••••••••••••••••••••••••••••••••••••••••••••••••
In This Section
About the 4285 & 4286 VIP Module
Installing the VIP (Phone Module)
Programming the 4285/4286 VIP Module
Checking 4285/4286 VIP Module Operation
••••••••••••••••••••••••••••••••••••••••••••••••••
About the 4285 & 4286 VIP (Voice Interactive Phone) Module
The 4285 or 4286 VIP Module is an add-on accessory for the VISTA-15/VISTA-15CN that
permits access to the security system via a TouchTone phone (either on-premises or by a call-
in when away). The 4286 VIP Module has the additional capability of controlling
thermostat(s) and providing external speaker output.
The VIP (Voice Interactive Phone) can announce many of the same words that would
normally be displayed on an alpha keypad under the same system conditions.
Only one VIP Module can be used in this security system.
When properly connected, the 4285/4286 VIP Module enables the user to do the following via
a TouchTone telephone:
Receive synthesized voice messages over the phone regarding the status of the security
system.
Arm and disarm the security system and perform most other commands using the
telephone keypad, with voice annunciation over the phone confirming any command that
is entered.
The phone used for phone access must have TouchTone capability, though TouchTone service
is not necessary. (If premises uses pulse dialing, switchable phones must be set for
TouchTone temporarily before attempting phone access.)
A Phone Access User's Guide for phone access to the security system is provided with the
VIP (phone module) for the user of the system.
Installing the VIP Module
Mounting the 4285 or 4286 VIP Module
The VIP (phone module) may be mounted in the control cabinet if space is available or, if this
is not possible, on the side of the cabinet or adjacent to it.
When mounting the module outside the cabinet, use the screw holes at its rear, which permit
it to be mounted horizontally or vertically. (You may use double-sided adhesive tape if you
prefer.) Wires can be brought out from the side or back (a round knockout is also available on
the back).
Stick the VIP module’s connections
label (supplied separately) to the inside of the phone
module's cover, if the cover is used. If you have installed the module within the cabinet, stick
the label to the inside of the control cabinet's door.
Vue de la page 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 131 132

Commentaires sur ces manuels

Pas de commentaire