ADEMCO Vista Guide de l'utilisateur télécharger pdf (Page 30)

– 30 –

TESTING THE SYSTEM

Walk in front of any interior motion detectors (if used) and

listen for three beeps. The identification of the detector

should appear on the display when it is activated. The

display will clear when no motion is detected. Note that if

wireless motion detectors are used, there is a 3-minute

delay between activations. This is to conserve battery

life.

To test all smoke detectors, follow the manufacturer's

instructions. The identification of each detector should

appear on the display when each is activated.

If a problem is experienced with any protection point (no

confirming sounds, no display), CALL FOR SERVICE

IMMEDIATELY.

When all protection points have been checked and are

intact (closed), there should be no zone identification

numbers displayed on the keypad.

When testing is completed, exit the TEST mode by

continuing with step 5.

OFF

5. + 1 EXIT TEST MODE

(Security Code) Enter your security code and press the OFF key.

If the test mode is inadvertently left active, it

automatically turns off after 4 hours.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Pas de commentaire

ADEMCO Vista Guide de l'utilisateur Page 30