ADEMCO Vista Guide de l'utilisateur télécharger pdf (Page 29)

– 29 –

TESTING THE SYSTEM

(TO BE CONDUCTED WEEKLY)

Using the

TEST Key

The TEST key puts your system into the Test mode, which allows each protection

point to be checked for proper operation. The keypad sounds a single beep every 40

seconds as a reminder that the system is in the Test mode.

Note:

An alarm message will not be sent to be sent to your alarm monitoring

company during the following tests.



DISARMED



READY TO ARM

DISARM THE SYSTEM

Disarm the system and close all protected windows,

doors, etc. The “Ready” message should be displayed

and the green READY indicator (if present on the

keypad) should also be lit .

TEST

2. + 5 ENTER THE SECURITY CODE THEN PRESS TEST

(Security Code)

Example: 7 2 9 6 then press the TEST key.

3. LISTEN. The external sounder should sound for 2

seconds and then turn off.

If the sounder does not sound, CALL FOR SERVICE

IMMEDIATELY.

4. FAULT ZONES. Open each protected door and window

in turn and listen for three beeps from the keypad.

Identification of each faulted protection point should

appear on the display. The display will clear when the

door or window is closed.

(Continued)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Pas de commentaire

ADEMCO Vista Guide de l'utilisateur Page 29