ADEMCO VISTA-128B Guide d'installation télécharger pdf (Page 146)

VISTA-128B Installation Instructions

23-8

010 INPUT S/N

Axxx-xxxx

This prompt is displayed if 1 (YES) is entered in response to

the "LEARN S/N?" prompt. The serial number may be enrolled

by one of two methods:

a) Enter the 7-digit serial number printed on the device

using an alpha keypad.

b) Activate the device by faulting or restoring the input you

wish to use for that zone (e.g., press a button, open or

close a door, etc.).

010 INPUT S/N

A022-4064

The system will enroll the serial number of the first device

heard.

If the serial and loop number combination is already present in the system, the keypad will sound

a single long beep and display the word "DUPLICATE" along with the serial number, and the

number of the zone containing the serial/loop number combination.

The system will then enter an optional confirmation mode so that the operation of the actual

programmed input can be confirmed. Activate the loop input or button that corresponds to

this zone. We recommend that you confirm the programming of every device before

proceeding to the next zone.

010 CONFIRM RF:1

A022-4064 1

When the system sees activity on the appropriate input, it will

beep three times and display the confirmation message.

At any time during this step, you may press the

[*]

key on the keypad or the upper left-hand

button of the program tool if you are satisfied with the serial and loop number combination that has

been enrolled, regardless of whether or not the enrolled input has been "confirmed."

If the incorrect device has been enrolled, press the [#] key on the keypad or upper right-hand

button on the program tool to delete the serial number and return to the "LEARN S/N" prompt. A

single long beep will be heard from the keypad to verify pressing of the upper right-hand button.

Then, press

(Yes) or press the upper left-hand button of the program tool (a single short beep

will verify the system is ready for enrolling) and re-activate the proper device loop input.

010 ZT P RC B INL

s 03 2 3C 0 RF1

The summary screen for the zone will appear. Note that an "s"

indicates that a serial number has, in fact, been enrolled. Press

[*] to accept the zone information.

If you want to delete the serial number, press [#]. This will

bring you back to the “INPUT TYPE” prompt. Press [*] to

change input type, loop number, and serial number.

When you have finished programming all zones, test each using the system's Test Mode. Do not

use the Transmitter ID Sniffer Mode for this, as it will only check for transmission of one zone on a

particular transmitter, NOT the zones assigned to each additional loop, and will not verify polling

loop type zones.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 251 252

Commentaires sur ces manuels

Pas de commentaire

ADEMCO VISTA-128B Guide d'installation Page 146

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité ADEMCO VISTA-128B