ADEMCO Vista-128FB Manuel d'utilisateur télécharger pdf (Page 42)

– 42 –

XXX Assigned Zone

000=QUIT 000

Press [∗] to scroll through all zones in that list. Enter 000 +[∗]

to quit.

Press *99 to exit Program Mode.

Relay Voice Descriptors

If using the 4285/4286 VIP Module, voice descriptors can be programmed for each of the 32 relays used in

the system. These descriptors will be announced by the voice module when accessing the relays via the # 70

Relay Access Mode via telephone.

Each voice descriptor can consist of up to 3 words selected from the relay voice descriptor vocabulary list

(later in this section).

The index numbers from this vocabulary list are to be used for relay voice descriptors only. For

normal system voice annunciation (e.g., alarms, troubles, status), use the highlighted words in the

alpha vocabulary list in the

Alpha Programming

part of this section.

To enter relay voice descriptors, do the following:

From Data Field Programming Mode, press #93 to display the "ZONE PROG?" prompt.

Press 0 (NO) to each menu option until the "RLY VOICE DESCR?" prompt is displayed.

Follow the instructions below. While in this mode, press [∗] to advance to next screen.

Press [#] to back up to previous screen.

RLY VOICE DESCR?

0=no 1=yes

Press

to program voice descriptors for relays.

ENTER RELAY NO.

00=QUIT 01

Enter the 2-digit relay number (

01-32

) for the relay desired, or

enter

to quit Relay Voice Descriptor Programming Mode.

Press

[

∗

01 ENTER DESC d1

From the relay voice descriptor vocabulary list, enter the 3-

digit index number for the first word of the relay descriptor

phrase. Press [

∗

] to accept entry.

01 ENTER DESC d2

From the relay voice descriptor vocabulary list, enter the 3-

digit index number for the second word of the relay descriptor

phrase. If second word is not desired, press

000

Press

[

∗

] to accept entry.

01 ENTER DESC d3

From the relay voice descriptor vocabulary list, enter the 3-

digit index number for the third word of the relay descriptor

phrase. If third word is not desired, press

000

Press

[

∗

] to accept entry. The “ENTER RELAY NO.” prompt

will appear. Enter the next relay number to be programmed.

When all output devices have been programmed, enter

quit.

Enter *99 to exit Program Mode.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

ADEMCO Vista-128FB Manuel d'utilisateur Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité ADEMCO Vista-128FB