ADEMCO Vista-128FB Manuel d'utilisateur télécharger pdf (Page 38)

– 38 –

If a specific "ZONE TYPE" is chosen, any zone of that response type

going into alarm, trouble, or fault will cause the device to activate as

selected in "ACTION.” If the same “ZONE TYPE” is also chosen for the

STOP programming, any zone of that type that restores will de-

activate the device.

If a "SYSTEM OPERATION" is chosen, that operation will cause the

device to activate as selected in "ACTION.” The different choices for

"ZONE TYPE" and "SYSTEM OPERATION" are listed in

“Programming Relays” later in this section, and on the Programming

Form.

3) PARTITION No. (P). The device's "Start" ZONE TYPE/SYSTEM

OPERATION may be limited to an occurrence on one partition (1-8), or

any partition (0).

STOP (STP):

The "STOP" programming determines when and under what conditions

the device will be de-activated. The following options are available:

1). RESTORE ZONE LIST (ZL). If a "ZONE LIST" is used as the “Stop”

event, the device will de-activate when all the zones in that list restore

from a previous fault, trouble, or alarm condition. This will occur

regardless of what is programmed to "START" the device; therefore, a

"RESTORE ZONE LIST" would normally only be used when a "ZONE

LIST" is used to start the device.

2). ZONE TYPE/SYSTEM OPERATION (ZT). Instead of using a

"RESTORE ZONE LIST," a specific zone (response) type or system

operation action can be selected to de-activate the device.

If a specific "ZONE TYPE" is chosen, any zone of that response type

that restores from a previous alarm, trouble, or fault condition will

cause the device to de-activate.

If a "SYSTEM OPERATION" is chosen, that operation will cause the

device to de-activate. The different choices for "ZONE TYPE" and

"SYSTEM OPERATION" are listed in “Programming Relays” later in

this section, and in the Programming Form.

3) PARTITION No. (P). The device's "Stop" Zone Type/System

Operation may be limited to an occurrence on one partition (1-8), or on

any partition (0).

The “ZONE TYPE/SYSTEM OPERATION” option functions

independently of the “EVENT/ZONE LIST” combination.

Relay Output Devices Programming

From Data Field Programming Mode, press #93 to display the "ZONE PROG?" prompt. Press 0 (NO)

to each menu option until the "RELAY PROG?" prompt appears. Press 1 (YES).

While in this mode, press [∗] to advance to next screen. Press [#] to backup to the previous screen.

ENTER RELAY NO.

(00=QUIT) 01

Enter the relay (output device) identification number 01-16.

This is a reference number only, used for identification

purposes. The actual module address and relay number on the

module are programmed in the last two prompts.

Press [∗] to continue.

02 A EV ZL ZT P

STT 0 0 0 00

Press [∗] to continue.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

ADEMCO Vista-128FB Manuel d'utilisateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité ADEMCO Vista-128FB