ADEMCO VISTA-20HWse Guide de dépannage télécharger pdf (Page 57)

–57–

Summary Mode Display

Default Descriptor [

S ZN 01 ZONE 01

If a descriptor was not entered

previously for zone 1, the default

descriptor for zone 1 will be displayed.

Note that this a “summary mode”, and

that no entries can be made. Entries

can be made only when the display

contains a flashing cursor, which

signifies the “entry mode”.

Flashing Cursor (system is

ready for entry of word).

[

S ZN 01

5. To delete or change the default

descriptor for zone 1, press

*

plus the

same zone number (01). This will

clear that descriptor and allow changes

to be made at the flashing cursor.

NOTE: If you do not wish to change the

existing descriptor for zone 1, enter [

*

]

plus the next zone number for which

you wish to enter (or check) a

descriptor. A summary display for that

zone will appear. You must then press

[

*

] plus the same zone number again to

gain access to the entry mode (flashing

cursor) for that zone.

Flashing Cursor

[

S ZN 01 B ACK

S ZN 01 BACK

+

Flashing Cursor if “6” is

pressed

(system is ready for

next word).

6. Press [#] plus 3-digit number for the

first word from the “Alpha Vocabulary

List”. Example: The descriptor that we

wish to enter for zone 1 is BACK

DOOR. From the list, BACK = 013.

Therefore, you would enter # 0 1 3.

Note:Ê If you accidentally enter the

wrong word, simply press [#] plus the

correct 3-digit number for the word you

want.

7. Press Ò6Ó to accept the selected

word and continue.

NOTE:

If this is the only word you are

using for the descriptor, press “8”

instead of “6 ” to save that word in

memory, and then go to step 11.

S ZN 01 BACK

D OOR

+Flashing Cursor

8. Enter the 3-digit number for the next

word. In our example, the word is

DOOR, whose number is “057”.

Enter # 0 5 7. This display will appear:

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 83 84

Commentaires sur ces manuels

Pas de commentaire