VISTA-128BP/VISTA-250BP Installation and Setup Guide
4-2
programming mode to display the first choice of the
menu-driven programming functions. Press 0 (NO) or
1 (YES) in response to the displayed menu selection.
Pressing 0 will display the next choice in sequence.
Below is a list of the main menus. For details refer to the VISTA-128BP/VISTA-250BP Programming Guide.
MAIN MENU
OPTIONS
ZONE PROG?
1 = YES 0 = NO 0
For programming the following:
• Zone Number
• Zone Response Type
• Partition Number for Zone
• Dialer report code for zone
• Input Device Type for zone (whether RF, polling loop,
etc.)
• Enrolling serial numbers of 5800 Series transmitters &
serial polling loop devices into the system.
• Zone Attributes (e.g., Arm w/Fault, Silent, etc.).
EXPERT MODE?
1 = YES 0 = NO 0
Same as Zone Programming except:
• Done with a minimum number of keystrokes.
• Can program wireless keys using pre-defined templates.
REPORT CODE PROG?
1 = YES 0 = NO 0
For programming the following:
• Alarm report codes for zones
• Restore and supervisory codes
• All other system report codes
ALPHA PROG?
1 = YES 0 = NO 0
For entering alpha descriptors for the following:
• Zone Descriptors
• Installer’s Message
• Custom Words
• Partition Descriptors
• Relay Descriptors
DEVICE PROG?
1 = YES 0 = NO 0
For defining the following device characteristics for addressable devices, including keypads, RF receivers
(5881), output relay modules (4204/4204CF), FSA (FSA-8/FSA-24), 4285/4286 VIP Module, Panel Link Module
(VA8201), ECP long range radio (7845C), and VISTA Gateway Module:
• Device Address
• Device Type
• Keypad Options (including Partition assignment)
• RF House ID
• LRR Options (including Programming radio)
OUTPUT PGM?
1 = YES 0 = NO 0
For defining output device functions.
RLY VOICE DESCR?
1 = YES 0 = NO 0
For entering voice descriptors for relays to be used with the 4285/4286 VIP Module.
CUSTOM INDEX ?
1 = YES 0 = NO 0
For creating custom word substitutes for VIP Module annunciation.
ACCESS POINT PGM
1 = YES 0 = NO 0
For defining the parameters for each of the VistaKey zones, including which group(s) have access through an
access point (door). See the
VistaKey-SK Installation and Setup Guide
for detailed programming instructions.
ACCESS GRP PGM
1 = YES 0 = NO 0
For defining the capabilities (privileges) for each group of users. See the
VistaKey-SK Installation and Setup
Guide
for detailed programming instructions.
EVENT/ACTION PGM
1 = YES 0 = NO 0
For defining events and time windows for an access group. See the
VistaKey-SK Installation and Setup Guide
for detailed programming instructions.
SCHEDULED CHK-IN
For defining the schedule for the system to automatically call the downloader.
Commentaires sur ces manuels