ADEMCO Vista-128FB Guide d'installation télécharger pdf (Page 21)

3-1

SECTION 3

Installing the Control

••••••••••••••••••••••••••••••••••••••••••••••••

•

This section describes the procedures for mounting and wiring the control panel and all the peripheral devices.

NOTE: All references in this manual for number of zones, number of user codes, number of access cards,

and the event log capacity, use the VISTA-250BP’s features. See SECTION 1: General Description for the

table listing the differences between the VISTA-128BP and the VISTA-250BP control panels.

Mounting the Control Cabinet

To mount the control cabinet, perform the following steps:

Step Action

1 Before mounting the circuit board, remove the metal knockouts for the wiring entry that you will be using.

DO NOT ATTEMPT TO REMOVE THE KNOCKOUTS AFTER THE CIRCUIT BOARD HAS BEEN

INSTALLED.

2 Using fasteners or anchors (not supplied), mount the control cabinet to a sturdy wall in a clean, dry area

that is not readily accessible to the general public. The back of the cabinet has 4 holes for this purpose.

To provide certificated burglary service for UL installations, refer to the special requirements and

Figure 3-2

Cabinet Attack Resistance Considerations

to follow. For UL Commercial Burglary installations that require

ATTACK RESISTANCE, use the cabinet included in the VISTA-ULKT kit.

Installing the Cabinet Lock

1. Remove cabinet door, then remove the lock

knockout from the door. Insert the key into

the lock.

2. Position the lock in the hole, making certain

that the latch will make contact with the latch

bracket when the door is closed.

3. When correctly positioned, push the lock until

it is held securely by its snap tabs.

Use an ADEMCO No. K4445 Lock (supplied).

CABINET DOOR

BOTTOM

LOCKED

UNLOCKED

cab_lock_snap-001-V0

ADEMCO

PUSH

SNAP

TAB

SNAP

TAB

PUSH

ON LOCK

UNTIL IT

IS SEATED

SECURELY

STEP 2STEP 1

CHECK

POSITION

Figure 3-1: Installing the Lock

Grade A Mercantile Premises Listing Guidelines

• The panel door must be supervised. Mount the

clip-on tamper switch (supplied) to the cabinet's

right side wall as shown in the diagram below,

and wire it to one of the hardwire zones.

• Use a bell with a tamper-protected housing such

as the ADEMCO AB12. The bell housing's tamper

switch and inner tamper linings must also be

wired to the hardwire zone.

• Assign the tampers’ hardwire zone to a burglary

partition. Program the hardwire zone for day

trouble/night alarm (zone type 5) when only one

burglary partition is used. Program it for 24-hr.

audible alarm (zone type 7) when more than one

burglary partition is used.

• All wiring between the bell and panel must be run

in conduit. Remaining wires do not need to be run

in conduit.

• All wiring that is not run in conduit must exit

from the knockout openings on the bottom or back

of the cabinet.

• All unused knockouts must be plugged using the

disc plugs and carriage bolts (supplied), as

indicated in the diagram below.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 146 147

Commentaires sur ces manuels

Pas de commentaire

ADEMCO Vista-128FB Guide d'installation Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité ADEMCO Vista-128FB