ADEMCO Vista 4130XT Manuel d'instructions télécharger pdf (Page 21)

The optional No. 4152LM Loop Module is installed onto the No4171XT

b. Secure the No. 4152LM by means of 3 srews (supplied).

Digital Communications Interface board as follows, referring to Diagram 5.

Connect two wires from the looD terminals (1 and 2) on the 4152LM to

Note the 8 square-shaped connector pins on the 4171 XT board. PosI-

termnals 11 and 12 (respectively) on the “4208 Zone Expander. For

tlon the 4152LM board” over the 4171 XT board so that these pins

information on wire usag”e, etc., ~efer to a prewous section entitled

engage the mating sockets (header) on the underside of the 4152LM.

“ZONE EXPANSION”.

Press the 4152LM down until the pins are fully seated.

‘=Q&

‘CONTROL 130AR0

CONNECTOR

PINS

Diagram 5. No. 4152LM INSTALLATION

AND WIRING TO No. 4208

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 83 84

Pas de commentaire

ADEMCO Vista 4130XT Manuel d'instructions Page 21