ADEMCO LYNXR24 Manuel d'installation télécharger pdf (Page 34)

– 34 –

86(5)81&7,216

5HPRWH3KRQH&RQWURO)HDWXUH

Enter:

Upon entering remote phone control mode the Lynx will announce “System, enter code”.

Remote Phone Control Commands

To remotely disarm system:

To remotely arm in AWAY mode:

To remotely arm in STAY mode:

To remotely arm in AWAY or STAY mode with no delay:

To remotely activate X-10 devices 1-6:

To remotely activate X-10 devices 7 & 8:

To remotely deactivate X-10 devices 1-6:

To remotely deactivate X-10 devices 7 & 8:

To remotely Bypass zones:

To remotely activate Forced Bypass:

To remotely check system status:

[*]

To end remote phone session:

NOTES

: (1) Check with your installer to see if the Forced Bypass mode has been enabled.

(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been bypassed.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 55 56

Pas de commentaire

ADEMCO LYNXR24 Manuel d'installation Page 34