ADEMCO 4160-12 C-COM Spécifications télécharger pdf (Page 45)

~. L~ ~RD S- PR~ORS

~~1~:

Do not rmove or insert any of the Ho. 685*S drdt cards

tithout first turdng off the

MO. 6X1S AC ~er, ss *1 ss

tisconneetingthe standby battery.

Group E~bsr S~aetion:

The ~oup number is the second digit of the receiver~s display (it follms

the receiver number).

It identifiae the phone line on which a cdl was

received. In the mse where mtitiple @one lines are set up as a rotary

group, the group number may be used to identify the rotary group number.

1. Locate the ~oup nmher sdector stit~ on the ltie card (see Diagra

5).

Hold the line card with the cm~nen~ toward you sod the gold

fingsrs downward.

The switch is a small square com~nant with the

numer~s O to 9 printed on it snd is located in the upper ri@t-h~d

corner of the bo=d.

2. Rotate the canter part of the swit& (use a small screwdriver)until

the *row thereon points to the desired line nwmter (1-8). D O NOT

attampt to use the number O or 9 for the line nmber.

B. ~~ SP~ my Option (No. 685-2 ~GH/LOW SPEED Format Line Csrde otiy):

If an Ademco High Spsed cmunicating devioe is progr~ed to cdl the

No. 685-2 HIGH/LOW SPEED Line Card,

trmsmission shntid occur autma-

tictily at ~GH SFSED. No changes are required at the communi eating

detice. The No. 685-2 sends a HIGH SPEED acknowled~ent tone once (or

twice, if necess=y). If a ~GH SPSSD response does not occur , the

No. 685-2 will send a stmdsrd acknowledgment tone.

Standard (LOW SPEED

fomat ) commticating devices can thus operate with the No. 685-2 as well.

It ~so me~s that high speed ~mmunicsting devices (unless specifically

pro~smmed otherwise)wfll transmit at LOW SPEED if, due to line noise, for

e-pie, it fails to respnd to the two HIGH SPEED achowledgments . In

some communicators,if they have been programmed for a four-digit acmunt

n~ber (i.e.~ ~~ting ~t a =ro in the first position), the account

nm~r will change at

LOW SPEED (e.g.,

1258 becom= 0258).

To avoid

possible errors, we recommend otiy having high speed communicators cdl in

to a No, 685-2 card dedimted to HIGH SPEED ofly.

To convert the card to a ~~ SPSSD ofiy card, cut the WHITE loop jm~r

located in the upper right-hand corner of the line card. %ke sure that

the free ends of the wire mnnot short to any adjacent sre~ .

Slff Cmunicatw Option:

The No. 685 will wait up to 3.5 seconds tetween the end of the handshake

tone and the start of the first message.

Also, it will wait up to 5

seconds tetween messages before hsn~ng up.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

ADEMCO 4160-12 C-COM Spécifications Page 45

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité ADEMCO 4160-12 C-COM