ADEMCO Vista-20HW Guide de dépannage télécharger pdf (Page 29)

10 Report Code

1st 03 2nd 12 3C

Typicalsummarydisplay

The report code consists of 2 hexadecimal digits,

each in turn consisting of 2 numerical digits. For

example, for a report code of “3C”, enter [0][3]

for “3” and [1][2] for “C”. Refer to Section 15.

SYSTEM COMMUNICATION for complete

information on report codes, if necessary.

Enter the report code and then press [*] to

continue.

A summary display will appear, showing the

data for the zone that was just programmed.

Note that AW indicates an auxiliary wired (zone

expansion module) zone.

If it is programmed satisfactorily, press [*I to

display the next prompt.

For all zone types, the next request is to enter

Alpha descriptors for the zones. The entry may

be done now (enter 1) or maybe done at a later

time usin *82 interactive mode (enter O). We

recommen that the entry of Alpha descriptors

be done later using *82 interactive menu mode.

See Section 14. ALPHA DESCRIPTION

PROGRAMMING for specific procedure.

‘lpretiouslY

If “O” (No) was entered above, the system will

display a prompt for entry of the next wired

expansion zone number. Proceed with the

programming for the next zone, as indicated

When you have programmed all the wired

expansion zones satisfactorily, exit *56

interactive mode at the Enter Zn Nurn. prompt

by pressing [01 [01 *.

Then exit the programming mode by keying $4)!3.

Proceed to the check-out procedure that follows.

-28-

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 99 100

Pas de commentaire

ADEMCO Vista-20HW Guide de dépannage Page 29